$
Muting or Soloing
an Instrument
Memory
Muting an Instrument$
Soloing an Instrument
5. Use the select switch to choose the
instrument that you want to use as a
metronome (for example, RS: Rim
Shot).
6. Press the STEP NO [1]–[16] button
that will start the beat (Sounding the
Metronome step). $
7. Use the select switch to specify an
instrument that you want to write by
tapping. $
8. Press the [TAP] button at the
desired timing.$
The LEDs light to indicate the step
numbers that are closest to the timing
of each tap. $
9. To write the steps for other
instruments or for the accent, repeat
steps 7–8. $
10. When you’ve finished writing, once
again select the instrument that you
selected in step 5, and clear the $
notes that you had been using as the
metronome. $
11. Press the [START/STOP] button. $
Within the same basic rhythm (or intro/
fill-in), A and B have the same number
of steps and the same pre-scale
1. Hold down the [BANK/TEMPO/
SHUFFLE] button and press the
[TRIGGER OUT] button.
2. Continue holding down the [BANK/
TEMPO/SHUFFLE] and [TRIGGER
OUT] buttons, and use [2]–[12] to
select the instrument that you want to
mute.
1. Hold down the [BANK/TEMPO/
SHUFFLE] button and press the
[TRIGGER OUT] button. $
2. Continue holding down the [BANK/
TEMPO/SHUFFLE] and [TRIGGER
OUT] buttons, and use [TAP] to
choose “SOLO.” $
3. Continue holding down the [BANK/
TEMPO/SHUFFLE] and [TRIGGER
To Next Page
Loading...
