BASIC COURSE
This Basic Course will provide essential information needed to satisfactorily operate
the TR-606 Drumatix. For complete information and more complex applications, refer
to the Advanced Course Manual
.
Basic Connections
Output
to guitar amp/to audio amp [or just send it straight into your mixer or multitrack - ed]
Headphone jack
to headphones
AC Adaptor jack
Please connect a Boss ACA Battery Eliminator to this socket.
Do not connect any other brand of Battery Eliminator as this could damage the
internal circuitry of the TR-606.
Caution
It should be noted that when using the TR-606 by itself (without interfacing with
other units using the SYNC connection), the SYNC INPUT/OUTPUT switch on the
back panel should be set to the OUTPUT position. The TR-606 will not operate with
this switch at the INPUT position.
Choosing Amplification
The TR-606 Rhythm Composer may be monitored through any conventional
amplification, but ideal amplification will reproduce its realistic drum sounds
faithfully with a minimum of added distortion and coloration.
Audio OUTPUT
The OUTPUT jack on the back panel of the TR-606 presents the summed output of
the individual INSTRUMENT MIX LEVEL (E) controls as adjusted by the master
VOLUME (A) control to allow very precise control over the TR-606 final output
level and balance.
HEADPHONE Jack
The TR-606 also provides self-contained amplification for any conventional stereo
headphones through a 1/4 inch phone jack on the back panel. The HEADPHONE
OUTPUT level is controlled by the master VOLUME control (A) in combination with
the individual INSTRUMENT MIX LEVEL (E) controls.
Battery Eliminator
The TR-606 is fully portable, normally relying on batteries for all internal functions
and to power the self-contained Headphone amplifier. To extend battery life, merely
connect a BOSS ACA Battery Eliminator to this socket.
To Next Page
Loading...
