SD . . . . . . . .Snare Drum
LT . . . . . . . .Low Tom
HT . . . . . . . .High Tom
CY . . . . . . . .Cymbal
OH . . . . . . . .Open Hi-Hat
CH . . . . . . . .Closed Hi-Hat
AC . . . . . . . .Accent
* If you want to erase a note, simply press the respective SELECTOR switch
(K). When you want to erase all of the notes of the selected instrument, hold
the CLEAR/RESET button (F) down until all the notes are cleared.
* Erasing is completed when all the LED indicator (L) lights are out.
14. The pattern can also be written in real time by using the TAP method (M).
While the Rhythm is running, just press the TAP button (M) at the appropriate
places in the measure.
15. Press the RUN/STOP button (H).
* You have just written the Rhythm Pattern indicated in Fig. 1 into the
computer memory.
IMPORTANT NOTES
When pressing the button, do not fail to release it once, and go on to the next
operation, except for the cases that it is specifically instructed to keep pressing
the button. (The TR-606 does not function properly if you go on to the next
operation without releasing the button.)
16. Now, write the Rhythm Patterns in Fig. 2 into the assigned memory locations
by repeating the procedures 6 to 15.
Fig. 2
* POSITION --> PATTERN GROUP I-1
1234567890123456
BD x------xx-x---x-
SD ----x-------xx--
OH --x---x---x---x-
CH xxxxxxxxxxxxxxxx
AC x-x-x-x-x-x-x-x-
* POSITION --> PATTERN GROUP I-2
1234567890123456
BD x------xx--x----
SD ----x-----------
LT ------------xxxx
HT --------xxx-----
OH --x---x----x----
CH xx--xx--x---x---
AC x-x-x-x-x--x--x-
* POSITION --> PATTERN GROUP I-3
1234567890123456
BD x------xx-------
SD --x--x--x--x----
LT --------------x-
HT ------------x---
CY x---------------
OH --xx--xx--xxx---
CH xxx-xxx-xxxx--xx
AC x-xx-xx-x-xxx-x-
To Next Page
Loading...
