NQPSMTR
Supplemental Notes
© 1997 Roland Corporation U.S. Re-initialization Procedures Page 7 of 9
R-880 No ROM reset.
RA-30 The unit resets each time you turn it on.
RA-50 Power on while holding WRITE.
RA-90 Power on while holding WRITE.
RA-95 Power on while holding REC.
RA-800 (WARNING: This will erase the original factory Performance settings. However, you can
save them to disk before doing this procedure.) Power on while holding WRITE.
RD-500 Power on while holding NUMBER 1 and 8. Press DEC/YES.
RD-600 Press EDIT. Press the RIGHT PAGE button until “Initialize: All” is displayed. Press
INC/YES twice. Press EDIT to return to Play mode.
All Other RD No ROM reset.
RHODES 660 (Same as M-660.) While holding EDIT, press WRITE. Use PARAMETER UP (^) and
DOWN (v) to select ALL, then press WRITE. When completed, press EDIT to return to
Play Mode.
RHODES 760 (Same as M-760.) While holding EDIT, press WRITE. Use PARAMETER UP (^) and
DOWN (v) to select ALL, then press WRITE. When completed, press EDIT to return to
Play Mode.
RHODES MK-60 (Same as MK-60.) No ROM reset.
RHODES MK-80 (Same as MK-80.) While holding WRITE, press EDIT. While holding the LEFT (<) and
RIGHT (>) cursor buttons, press UP (^).
RSP-550 Power on while holding PROGRAM/PAGE UP (^) and DOWN (v), then press WRITE.
RSS-10 Power on while holding LOCK and OPTION. (The MCR-8 LED lights.) Press DEMO
PROGRAM four times. Press DEVICE ID.
RSS-8048 No ROM reset.
RV-70 Power on while holding WRITE and DOWN. Use the UP (^) and DOWN (v) buttons to
select AL. Press WRITE. Power off, then back on.
SB-55 Power on while holding CLEAR.
SBX-1000 No ROM reset.
S-Series No ROM reset.
SC-7 The unit resets each time you turn it on.
SC-33 Power on while holding REVERB and SPLIT, then press YES.
SC-50 Power on while holding both INSTRUMENT buttons, then press ALL.
SC-55 Power on while holding both INSTRUMENT buttons, then press ALL.
SC-55mkII Power on while holding both INSTRUMENT buttons, then press ALL.
SC-88 While holding SELECT, press both INSTRUMENT buttons. Press ALL.
SC-155 Power on while holding both INSTRUMENT buttons, then press ALL.
SCC-700C No ROM reset.
SD-35 Power on while holding CLEAR, then press REC.
SDD-320 No ROM reset.
SDE-330 Power on while holding SYSTEM and PROGRAM. Use the DATA dial to select SYSTEM
+ PROGRAM. Press MEMORY.
To Next Page
Loading...
