Roland TurboStart VS-880 - Page 19

NQPSMTR Supplemental Notes
© 1997 Roland Corporation U.S. Re-initialization Procedures Page 8 of 9
All Other SDE No ROM reset.
SDX-330 Power on while holding SYSTEM and PROGRAM. Use the DATA dial to select SYSTEM
+ PROGRAM. Press MEMORY.
SE-50 Power on while holding PARAM UP (^) and VALUE UP (^). Press WRITE. Wait three
seconds and press WRITE again.
SE-70 Power on while holding in the NUMBER/VALUE knob. Press PARAMETER LEFT (<),
then dial to STANDARD mode or GUITAR mode. Press WRITE.
SH-Series No ROM reset.
SN-700 No ROM reset.
SP-700 No ROM reset.
SPD-8 Power on while holding EDIT, then press COPY. Use the VALUE UP (^) and DOWN (v) to
select F A L in the window. Press ALL/ENTER.
SPD-11 Power on while holding ALL/ENTER and DOWN (the solid v). Press ALL/ENTER again.
SRC-2 No ROM reset.
SRV-330 Power on while holding SYSTEM and PROGRAM. Use the DATA dial to select SYSTEM
+ PROGRAM. Press MEMORY.
SRV-1000 No ROM reset.
SRV-2000 Factory: Power on while holding WRITE and REVERB NON-LINEAR.
Delay Mode: Power on while holding WRITE, REVERB NON-LINEAR and ROOM
SIMULATE.
SSC-8004 No ROM reset.
STUDIO M (Same as MV-30.) No ROM reset.
SUPER JUPITER (Same as MKS-80.) No ROM reset.
SUPER JX keybrd. (Same as JX-10.) No ROM reset.
SUPER JX module (Same as MKS-70.) No ROM reset.
SUPER QUARTET (Same as MKS-7.) No ROM reset.
All SYNTH PLUS (Same as HS-Series.) No ROM reset.
SX-700 Press UTILITY. Use PARAMETER LEFT (<) and RIGHT (>) to select FACT INIT. Press
WRITE.
TB-303 No ROM reset.
TD-5 Power on while holding EDIT and START/STOP, then press START/STOP again.
TD-7 Press SYSTEM. Use the LEFT (<) and RIGHT (>) CURSOR buttons to select INI, then
press ENTER. Cursor to HI HAT and use the DATA dial to select ALL. Press ENTER
twice.
TD-10 Press SETUP, then press F4 three times.
TL-Series No ROM reset.
TP-20 No ROM reset.
TR-505 Power on while holding MODE and PATTERN GROUP KEY A .
TR-626 Power on while holding MODE and TRACK #1.
TR-707 Power on while holding TRACK WRITE and TRACK #1 .
TR-727 Power on while holding TRACK WRITE and TRACK #1 .