7
Mar. 2008 V-8
fig.bunkaizu.eps@R
Important Notes When Replacing the T-Bar
The T-bar Assembly (#71789367) is available as an older type (1-A in the
figure) and a new type (1-B). The older type has a back fitting attached.
Similarly, the Shield Cover (#05121512) is also available as an older type (11-A)
and a new type (11-B). The older type has a wider opening.
When replacing the older-type T-bar Assembly (1-A) with the new type (1-B),
be sure to also replace the older-type Shield Cover (11-A) with the new type
(11-B).
That is to say, the new type of T-bar Assembly (1-B) must not be used in
combination with the older type of Shield Cover (11-A). Refer to the following
chart for the specific combinations that are acceptable.
* Only the new types (1-B and 11-B) are suppled as service parts.
T-bar Assembly Shield Cover Production numbers of
products where used
1-A 11-A Through ZW90699
1-B 11-B ZX00700 and after
T-bar Assembly Shield Cover Combination possible
1-A 11-A Good
1-A 11-B Good
1-B 11-A Not good
1-B 11-B Good
To Next Page
Loading...
