Roland V-Synth GT Service Notes

19
May, 2007 V-SYNTH/GT
How to Attach Keys
1. Place the spring on the chassis.
2. With the tip of the key angled downward, insert the key in the direction of the arrow shown in the figure.
3. Press down near the key shaft from above and fit the key into the shaft.
* Attaching a key with the spring not upright results in altered touch. Make sure the spring is not squeezed.
* Be sure to attach a black key while the white keys on both are uninstalled.
fig.SK-10-key-set-e.eps
1. Place the spring.
2. Lower the tip of the key and insert it from the front.
3. Press down on the key from above.
Lubricant Application Sites
When replacing keys or the sub-chassis, apply the specified lubricant at the locations shown in the figure.
fig.SK-10-grease-e.eps
Location Lubricant
1 Key and sub-chassis shaft area MOLYKOTE G-1039 (#17041858)
2 Spring bearing-surface area MOLYKOTE G-1039 (#17041858)
3 White- and black-key guide-bushing sides FLOIL G-336A (#17049543)
1. Place the spring.
2. Lower the tip of the key and insert it from the front.
3. Press down on the key from above.
2 Spring bearing-surface area
Apply the lubricant before placing the spring.
Spring
1
2
3

Roland V-Synth GT Specifications

General

Brand	Roland
Model	V-Synth GT
Category	Synthesizer
Language	English