Roland VAD506 - Page 12

12
KIT EDIT
POST EQ
This is a three-band equalizer.
Parameter Value Explanation
Low Frequency
20Hz–16kHz Center frequency of the low range
Low Gain
-40.0–+15.0dB Amount of low-range boost/cut
Mid Frequency
20Hz–16kHz Center frequency of the middle range
Mid Q
0.5–8.0 Adjusts the width of the frequency band. Higher values make the width narrower.
Mid Gain
-40.0–+15.0dB Amount of mid-range boost/cut
High Frequency
20Hz–16kHz Center frequency of the high range
High Gain
-40.0–+15.0dB Amount of high-range boost/cut
TOTAL COMP
This is a compressor applied at the last stage of the overhead sound.
Parameter Value Explanation
Post Comp Switch
OFF, ON Turns the total comp on/o.
Gain
-24.0–+24.0dB Output volume of the total comp
Threshold
-60–0dB Volume level at which compression begins
Ratio
1:1–100:1 Compression ratio
Knee
HARD, SOFT1–3 Attack of the sound at the moment compression is applied
Attack
0.1–100mSec Time from when the volume goes up the threshold level until the compressor eect applies
Release
10–1000mSec
Time from when the volume falls below the threshold level until the compressor eect no longer
applies