4
Selecting Patches by Category
Patches can be categorized into different groups to make
them easier to find. There are a numerous preset categories,
such as ROCK, JAZZ, CLEAN, etc., as well as 10 different user
categories.
To select a patch by category:
Press the CATEGORY button.
1
Use the F1 and F2 knobs and/or buttons to choose the desired 2
category.
Use the F3 and F4 knobs and/or buttons or PATCH/VALUE dial to
3
highlight the desired patch in the selected category.
Press EXIT to return to the Play screen.
4
If you don’t initiate any activity for a few seconds while the Category
screen is shown, the display automatically reverts back to the Play
screen.
Assigning a Patch to a Category
Select the patch.1
Press NAME/KEY/BPM.2
Press F1 (NAME).3
Press F6 (CATGRY).4
Use the F6 knob to select the desired category.5
Press EXIT three times to return to the Play screen.6
To save the category setting you’ve just made, you’ll need to save
the patch to a user patch location. We’ll discuss this procedure in a
little bit.
Naming a User Patch Category
With the factory settings, the 10 user patch categories are named “USER 1,”
“USER 2,” and so on. However, you can give each category a unique name if
you like. Here’s how:
Press SYSTEM.
1
Use the PAGE buttons to select Page 2 in the display. (The current 2
page number is shown in the upper right hand corner of the
display.)
Press F4 (CATGRY).
3
Use the F6 knob or button to select the user category you want to 4
name. The currently selected category is shown in the left side of the
display.
Enter the desired name for the category:5
To select a character—• use the PATCH/VALUE dial.
To change to a different character position—
• use the PAGE
buttons.
To insert or delete a character, or enter a blank space—
• use the
F1-F3 buttons.
To change the selected character’s type—
• use the F4 button.
To change the selected character’s case—
• use the F5 button.
Repeat Steps 5 and 6 to name other user categories.
6
Press EXIT twice to return to the Play screen. 7
To Next Page
Loading...
