Roland VG-99 - Page 5

5
Selecting Patches with the DIRECT PATCH Buttons
Another way to select patches from the front panel is with the five DIRECT
PATCH buttons. Just assign your five most-used patches to the buttons and
they’re at the ready for quick one-press access.
Assigning Patches to the DIRECT PATCH Buttons
Press SYSTEM.1
Use the PAGE buttons to select Page 1 in the display (the current page 2
number is shown in the upper right-hand corner of the display).
Press F2 (DIRECT).
3
Use the F1-F5 knobs to choose the patches assigned to the five 4
DIRECT PATCH buttons.
Press EXIT twice to return to the Play screen.
5
Selecting Patches with the CONTROL 1 and 2 Buttons
Various functions can be assigned to the CONTROL 1
and 2 buttons on the VG-99’s front panel. Two of the
many available are scrolling upward through patch
numbers (patch increment) and scrolling downward
through patch numbers (patch decrement).
Here’s how to assign patch decrement to CONTROL 1 and patch increment
to CONTROL 2:
Press SYSTEM.1
Use the PAGE buttons to select Page 1 in the display, and then press 2
F4 (CTL).
Again, use the PAGE buttons to select Page 1 in the display. This takes
3
you to the CONTROL ASSIGN screen.
Use the F2 and F3 knobs/buttons or button to highlight CTL1 in the
4
left column.
Use the F5 knob/button to select PATCH SELECT DEC in the right 5
column.
Use the F2 and F3 knobs/buttons or button to highlight CTL2 in the 6
left column.
Use the F5 knob/button to select PATCH SELECT INC in the right 7
column.
Press EXIT twice to return to the Play screen.8