Getting Ready
8
Turning the Power On/O
Turning the Power On
1. Before turning on this unit’s power, consider these two
questions:
• Is the AC adaptor and any other equipment connected
correctly?
• Have the volume controls of this unit and all connected audio
devices been turned to their lowest settings?
2. Press the [POWER] switch of this unit to turn it on.
3. Turn on the power for any connected audio devices.
4. While playing the keyboard and listening to the sound,
slowly increase the volume of this unit and the volume
of the connected equipment until you obtain the desired
volume.
Turning the Power O
1. Before turning o the power, consider the following
question:
• Have the volume controls of this unit and all connected audio
devices been turned to their lowest settings?
2. Turn o the power for all connected audio devices.
3. Turn o the [POWER] switch of this unit.
Concerning the Auto O function
The power to this unit will be turned o automatically after a
predetermined amount of time has passed since it was last used
for playing music, or its buttons or controls were operated (Auto
O function).
If you do not want the power to be turned o automatically,
disengage the Auto O function (p. 28).
• Any settings that you are in the process of editing will be lost
when the power is turned o. If you have any settings that you
want to keep, you should save them beforehand.
• To restore power, turn the power on again.
Listening to the Demo Songs
Here’s how to listen to the demo songs.
1. Turn the power on.
2. Press the [ ] (START/STOP) button.
3. Press the [ ] (START/STOP) button.
Demo playback starts.
When the selected demo song nishes playing, the next demo song
will begin playing.
4. Press the [ ] (START/STOP) button.
The demo song will stop playing.
MEMO
If the [LOOPER] button or [SONG/RHYTHM] button is lit, pressing
the [
] (START/STOP) button will not bring up the demo
screen.
* All rights reserved. Unauthorized use of this material for
purposes other than private, personal enjoyment is a violation
of applicable laws.
Using the Included USB Memory
Protector
You can use the included USB memory protector to prevent theft of
the USB ash drive connected to the VR-09.
NOTE
• You must use the included screws.
• You must use the included Allen wrench to tighten or remove
the screws. Using a tool that does not match the screw heads
will damage them.
• Be careful not to over-tighten the screws. Doing so may damage
the screw’s head, causing the wrench to rotate uselessly.
• To tighten the screws, turn the Allen wrench clockwise. To
loosen the screws, turn the Allen wrench counter-clockwise.
loosen tighten
• Keep the removed screws out of the reach of small children to
ensure they are not swallowed accidentally.
• Never allow foreign objects (e.g., coins, wires) to enter the USB
memory box.
• When opening/closing the USB ash drive cover, please be
careful not to get your ngers pinched between the movable
part and the panel. In places where small children are present,
make sure that an adult provides supervision and guidance.
VR-09 only
To Next Page
Loading...
