17
Remote Operating Instructions
DO NOT mix old and new batteries
DO NOT mix alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries.
AAA 1.5V
Remote Control Battery Installation:
Open the battery cover with a screwdriver. Place two "AAA"
(AM-4/LR03) batteries into the battery compartment and replace the
battery cover. Secure with the screw. Please note, the use of new
alkaline batteries is recommended for optimal performance.
If the red
light does not light up, please replace the batteries.
Pair Remote Control with E-Car:
1. Press and hold the forward, back and speed adjustment buttons at
the same time. The LED lights should ash when it is ready to pair.
2. Once the lights ash, press the vehicle's Power Button within 5
seconds. Then, the vehicle should pair automatically.
3. The lights on the remote will stop ashing, but remain on when the
vehicle is successfully paired. If the vehicle does not connect to the
remote, please repeat the above steps.
Speed adjustment
To Next Page
Loading...
