AIR COMPRESSOR
10
- Following this rule will reduce the risk of shock, re, or serious
injury.
- Make sure your extension cord is in good condition. When
using an extension cord, sure to use one heavy enough to carry
the current your product will draw. A wire gauge size (A.W.G)
of at least 14 is recommended for an extension cord 7.5 m or
less in length. A cord exceeding 15 m is not recommended. If
in doubt, use the next heavier gauge. The smaller the gauge
number, the heavier the cord. An undersized cord will cause a
drop in line voltage resulting in loss of power and overheating.
- This equipment incorporates parts, such as snap switches,
receptacles, and the like that tend to produce arcs or sparks
and, therefore, when located in a garage, it should be in a room
or enclosure provided for the purpose, or should be 460mm or
more above the oor.
- Never store a tool with air connected. Storing the tool with air
connected can result in unexpected ring and possible serious
personal injury.
- Protect your lungs. Wear a face or dust mask if the operation is
dusty. Following this rule will reduce the risk of serious personal
injury.
- If the power supply cord is damaged, it must be replaced only by
the manufacture or by an authorized service center to avoid risk.
- Save these instructions. Refer to them frequently and use
them to instruct others who may use this product.
- If you loan someone this product, loan them these instructions
also.
- The machine shall be connected to a circuit protection device
(fuse or circuit breaker). The protection device shall be set at 8 A
current, and the use shall do necessary test according to clause
18.2.2 of EN 60204-1:2006 to check if the protection device is
suitable for use.
- When the machine is in operation, many parts of machine may
cause a high temperature. Use as gloves to avoid injuries resulting
from a high temperature.
This appliance is not intended for use by persons (including
8
To Next Page
Loading...