Ronix RC-5010 - Using the Air Compressor

AIR COMPRESSOR
14
.TURNING THE AIR COMPRESSOR ON/OFF
1) With the air compressor plugged in, pull the power switch to
the ON position to power the compressor on.
2) To turn the air compressor off, push the power switch to the
OFF position.
NOTE:
When the compressor is in the ON position, the air compressor
will automatically turn back on when the designated tank air
pressure limit. It will also shut off again when the desired limit.
It will also shut off again when the desired pressure is reached.
WARNING!
Never exceed the air tool’s pressure rating as recommended by
the manufacturer. When using this air compressor as an ination
device, always follow the maximum ination guidelines stated
by the manufacturer of the item being inated.
WARNING!
Always ensure the switch is in the OFF (O) position and the
regulator pressure gauge reads zero before changing air outlet.
Failure to do so could result in possible serious personal injury.
USING THE AIR COMPRESSOR
1) Ensure power switch is in OFF (O) position and air compressor
is unplugged.
2) If not already installed, attach hose to compressor