Rorze RD-023MS - CE Marking and EMC Standards

To Next Page

To Previous Page

Overseas standards

■ CE Marking

It is obliged for manufacturers to append the CE Conformity Marking to the machine and the electric

product which are sold in the sphere of EU in order to display that those apparatus conform to safety, a

quality control, and environmental-destruction prevention.

As for the details of this regulation, a lot of EC council Directives ( or European Standards ) are issued,

and the above-mentioned apparatus needs to conform corresponding EC directives.

And manufacturers themselves need to create the self-declaration, which declares that the equipment

conforms to EC Directives, and to carry out the CE Marking pasting.

■ Standards of Conformity

Product Name

Application

Directive

Application

Standards

Certification File No

RD-023MS EMC

EN 50081-2

EN 50082-2

AE 9951219 03

● The use conditions for suiting EMC Directive

(1) A shield cable should be used for power supply line and signal line.

(2) Please put a ferrite core into each line.

In case of the CE Marking to a product, we perform the self-conformity declaration after receiving the

attestation of the third party certification body (TÜV Rheinland) in EU area.

Moreover, since RD-023MSs do not have the movable part which may do damage in a human body

and are used in the range of less than 40V DC, they do not correspond to Machinery Directive and

Low Voltage Directive.

The entire system including RD-023MS and all the control device and electric parts, is subject to EMC

Directive. Therefore, please make sure of the final EMC conformity of your system or machinery into

which those units are incorporated.

RD-023MS carries out the CE Marking

WWW.100Y.COM.TW WWW.100Y.COM.TW WWW.100Y.COM.TW

Related product manuals