RÖSLE G3 - For Storage; For the Gas Pressure Regulator

49
English
Safetyinstructionsforthegaspressureregulator
• Make sure that the gas pressure regulator is attached so that the small air outlet faces downwards and
no water can enter the hole. This air outlet must be kept clean and free of dirt, grease, insects, etc.
• No dirt may get into the gas pressure regulator or onto the screw xing.
• Before every startup, check the screw xings of the hose connection are tight. If necessary,
tighten with two open-end spanners.
• Only approved pressure regulators that correspond to the national operating pressure may be used.
Obtain information from your dealer.
• In order to guarantee proper functioning of the gas pressure regulator in normal operating conditions,
it is recommended that you replace the gas pressure regulator prior to the end of 10 years after the
date of manufacture. Deviating national regulations shall take precedence.
Safetyinstructionsforstorage
• Close the shutoff valve of the gas cylinder every time when the grill is not in use in order to
avoid any leaks.
• If the gas cylinder is not removed from the gas grill, the entire grill with the gas cylinder must be stored
outdoors in a well-ventilated location. Fuel gas is heavier than air. Escaping gas may collect in low level
locations and not disperse. Therefore, avoid entrances to basements, light shafts and water runoffs.
• If the gas grill is stored in an enclosed space, the gas cylinder must be removed from the grill. Gas cylin-
ders must be stored outdoors in a well-ventilated location and out of reach of children and third-party
access. Gas cylinders that have been removed may not be stored in buildings, garages or other enclosed
spaces.
• Nozzles, gas supply pipes and gas burners must be checked regularly for spider webs, insects, larva
cocoons and blockages by other factors.