Ross H Series - Maintenance and Care

www.rosseuropa.com
Operating Instructions | Air Preparation Products
11
START-UP
WARNING
System is operating under pressure!
 Incorrect installation could damage the maintenance
unit and cause serious injury.
 Before start-up, check that all connections, ports, and
modules have been correctly installed.
WARNING
Sudden surge in pressure during start-up!
 If no lling unit is used, the system will suddenly
be under pressure during start-up. This could cause
dangerous and sudden cylinder movements.
 When starting up a system without a unit, make sure
that the cylinders are in their end position. For cylinders
not in end position, make sure they do not present any
danger.
Before start-up, check:
• all connections for secure t,
• all modules of the maintenance unit for proper assembly,
• the oil-mist lubricator (if existing) for sufcient oil and
correct oil amount setting,
• the pressure regulator for correct setting,
• the lter module for properly equipped lters.
MAINTENANCE AND CARE
Relling oil
• Regularly check the oil level and rell if the oil has
reached the minimum lling height indicated on the
reservoir.
For tips on relling the oil, see Lubricator on page 9.
CHANGING THE FILTER ELEMENT
WARNING
System is operating under pressure!
 Opening the system when it ist under pressure could
damage the maintenance unit and cause serious injury.
 Ensure that the system is pressure-free before opening
the lter reservoir.
Filters become contaminated with use and must be changed
regularly:
for active carbon lters every six months, for all other lters
yearly. This, however, is only a recommendation, since the
interval depends on the quality of the compressed air and
the amount of air throughput.
CARING FOR THE MAINTENANCE UNIT
CAUTION
Solvents and aggressive cleaning agents!
 Solvents and aggressive cleaning agents damage the
polycarbonate container of the maintenance unit!
 Clean polycarbonate components only with a slightly
damp cloth. Use only water and, if necessary, a mind
cleaning agent without chemical additives.
Seal all openings with suitable protective caps to prevent de-
tergents from penetrating the system.
Never use solvents or strong detergents. Only clean the
product using a slightly damp cloth. Only use water and, if
necessary, a mild detergent.
Do not use high-pressure cleaners for cleaning.
Do not use compressed air for cleaning (blowing off) mainte-
nance units or maintenance devices.
DISPOSAL
Careless disposal of the maintenance units or its compo-
nents could cause environmental damage. Raw materials
cannot be recycled.
Dispose of the maintenance unit in accordance with your
country’s national regulations.