Ross H Series - Container and Protective Cage; Operation and Maintenance; Setting the Pressure

www.rosseuropa.com
Operating Instructions | Air Preparation Products
5
CONTAINER AND PROTECTIVE CAGE
Dismantling
• Screw off the union nut and remove it downwards.
• Unscrew the protective cage, if present, and remove it
downwards.
• Take off the container and seal by moving downwards.
Installing
• Position the seal into the grove in the head piece.
• Position the container onto the head piece.
• If required, t the protective cage in place over the
container.
• Fit the union nut over the container or the protective cage
and screw tight.
OPERATION
Setting the pressure
• Loosen the counter nut (b).
• Turn the handle (a) to set the desired pressure.
• Re-tighten the counter nut (b).
b
a
c
d
c
a
e
a
b