TROUBLESHOOTING CHART
TROUBLE CAUSE REMEDY
MN700-MC0010
8-4
5) Machine runs but makes a loud
banging noise at bottom of each
stroke. Guide frame may be hitting
side of conveyor.
Guide stop worn or broken
Inspect and replace as required.
6) Machine runs but makes a loud
banging noise on the up stroke.
Severe vibration. Excessive blade
bending.
NOTE: Damage to toggle
assemblies and blade will occur if
meat to thick for machine capacity is
processed.
Toggle not unlocking properly Check toggle and guide raiser assemblies.
Toggle clamp should pivot freely on the clamp
pivot, and both assemblies should be centered
on the uprights and toggle rod. Inspect for any
signs of wear or damage to the toggle and guide
raiser assemblies. Check condition of unlock
cushions. Replace any worn or damaged parts.
Both toggles must unlock at the same time.
Check position of snap-rings on main and guide
uprights.
(See section 7.3 for proper position).
NOTE: Severe vibration may loosen
fastenings throughout machine. Check
all nuts
and bolts for tightness.
Toggle ring broken Replace toggle ring. (See p 7-5).
7) Machine runs, but constant
vibration on up and down strokes.
Uprights may heat up or be scored.
Bearings and/or uprights worn
Inspect and replace bearings and uprights as
required.
TC700MC
TENDERIZER
To Next Page
Loading...
