TROUBLESHOOTING CHART
TROUBLE CAUSE REMEDY
MN700-MC0010
8-5
8) Machine runs, but conveyor does
not advance, or advances irregularly.
Cam follower out of adjustment
Remove side panel from the cabinet and
remove the conveyor box cover panel. Rotate
the conveyor drive shaft assembly until it is at
the extreme end of its lateral movement (either
way is OK). Loosen the lock nut on top of cam
follower (located in the center of the main
frame).
Rotate the motor manually until the cam plate is
at the top of its stroke. Adjust the screw at the
top of the cam follower so that the index pawl in
the conveyor box just contacts a tooth on the
index wheel. Tighten the lock nut on the top of
the cam follower.
Index pawl broken Replace as required.
Rocker bar spring broken Replace as required.
Pin holding index wheel to drive shaft broken
Replace as required.
9) Conveyor advances further than
normal.
Belt too loose. Tighten belt tensioning screws until overshoot
stops. Tighten both screws the same amount.
DO NOT OVER TIGHTEN. If necessary,
remove a link from the conveyor chain.
10) Conveyor belt jumps off of drive
shaft
Belt too loose Tighten belt tensioning screws until overshoot
stops. Tighten both screws the same amount.
DO NOT OVER TIGHTEN. If necessary,
remove a link from the conveyor chain.
TC700MC
TENDERIZER
To Next Page
Loading...
