TROUBLESHOOTING CHART
TROUBLE CAUSE REMEDY
MN700-MC0010
8-6
11) Excessive blade bending. See
Section 6
Operator not removing bent blades promptly
Train operator on the proper cleaning and
maintenance of machine. Blade assemblies
must be removed for daily cleaning and any
BENT OR DAMAGED BLADES REMOVED.
See Maintenance Section.
Reset pads worn Replace as required.
12) Meat lifts off of conveyor
Meat too thin to be held down by guide frame Stack thin cuts of meat so they will be held
down by the guide frame. See Operating
Procedures Section.
TC700MC
TENDERIZER
To Next Page
Loading...
