EasyManua.ls Logo

Rosslare AC-C31 - Programming the Ac-C31; Entering Programming Mode; Exiting Programming Mode

Rosslare AC-C31
17 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Programming the AC-C31
Programming the AC-C31 is done solely via the unit's keypad driven
Programming Menu System. To reach the Programming Menu
System the AC-C31 must first be placed into Programming Mode.
See "Entering Programming Mode" on Page 17 for more
information.
During the AC-C31's manufacturing process certain codes and
settings are pre-programmed. These settings are the called the
"Default Factory Settings".
The table below shows the names of all the AC-C31 Menus. It also
shows of all the AY-C31’s default factory codes and settings.
2580 Change Open Code 1 1
0852 Change Open Code 2 2
1234 Change Program Code 3
3838 Change Normal / Secure Code 4
N/A Change Normal / Bypass Code 5
0004 Change Door Release Time 6
Enroll PIN Code. 7
Delete PIN Code 8
Return to Default Factory Setting 0
You will find a complete description and instructions for each of the
above menu items on the following pages.
Programming Menu
Page 16
06/01
AC-C31
Page 17
06/01
Entering Programming Mode
Exiting Programming Mode
1) "#"
2)
Note:
1)
"#"
2)
3)
4) "#"
Press the key for 2 seconds.
Mode LED will turn off
Door LED will turn red
Enter your 4-digit Programming
Code.
If the Programming Code
is valid the door LED will turn
green and the AC-C31 will be in
Programming Mode.
- The AC-C31 must be in Normal Mode to enter the
Programming Mode.
- The factory default Programming Code is 1234
- If a Programming Code is not entered within 5 seconds,
the AC-C31 will return to Normal Mode.
To exit the Programming Mode at any time:
Press the key for 2 seconds.
You will hear 3 beeps.
The Door LED will be off
The Mode LED will turn green
This indicates that the AC-C31 has returned to Normal Mode.
Wrong entries may reset the controller back to Normal Mode.
While in Programming Mode if no key is pressed for 1 minute the
AC-C31 will exit programming mode and return to Normal Mode.
A short press on key may also return the system to Normal
Mode in certain Programming Modes.
!
!
!
!
!
AC-C31
Mode Door
Mode Door
GREEN
RED
12
3
4
Mode Door
GREEN
Menu Description
Factory
Settings
Menu
Number

Related product manuals