AC-G43
RT
Relay: An electronically controlled Tamper Siren: The alert sound
switch used for providing an Open activated when a Back Tamper or
Circuit or Closed Circuit output to Ca se Tam pe r ev en t oc cu rs .
external devices. (Requires the BL-D40 External
REX: An abbreviation of "Request Sounder)
To Exit". Tamper Siren Time: The time (user
Request To Exit (REX): Refers to a programmed) that the Tamper Siren
button which can release the door will sound when activated.
from inside. Commonly located at the
reception desk, or near a door as an
emergency door release.
S
Secondary Code: An additional
code issued to enable access in
Secured Mode. Users with non-
identical Primary and Secondary
Codes are Secure Users. Users with
identical Primary and Secondary
Codes are Master Users.
Secure Mode: The system setting
(Mode of Operation) in which only
valid Secure and Master Users have
access upon presenting a valid code.
Secure User: A user which has a
Primary Code and Secondary Code
that are non-identical, and can gain
access in any Mode of Operation.
Shunt: The arrangement in which an
external input (such as a door
monitor) is connected to the Auxiliary
Input, allowing the auxiliary output to
be activated after the Shunt Delay
elapses.
Shunt Delay: Is the delay time (user
programmed) used in Shunt (See
Shunt).
Strike: See Lock Strike
Page 42
07/04
AC-G43
Normal to Bypass Mode or vice
F
versa.
Fail Safe: The system setting in
Normal / Secure Code: The four
which a total power loss leaves the
digit code used to change the
connected door unlocked.
controllers Mode of Operation from
Fail Secure: The system setting in
Normal to Secure Mode or vice
which a total power loss leaves the
versa.
connected door locked.
Normal User: A user who only has a
Forced Door: A door which has
Primary Code and can only gain
been physically opened without the
access in Normal Mode.
access control device having
Normally Closed: A relay output
released the lock.
from the controller that is activated
Forced Door Time: The amount of
(closed circuit) under normal
time (user programmed) the
conditions.
controller waits in the event of a
Normally Open: A relay output from
Forced Door before the Auxiliary
the controller that is de-activated
Output is activated.
(open circuit) under normal
L
conditions.
Lock Strike: Term used for the
O
electronic or electromagnetic door
Open Code: The four digit code used
lock used for locking or unlocking the
to activate the Lock Strike Relay for
door.
testing purposes during installation.
Lock Strike Release Time: The
P
amount of time (user programmed)
that the Lock Strike remains Primary Code: The unique code
unlocked when a valid code is issued to enable access in Normal
entered. Mode. Users with only primary codes
are Normal Users.
M
Programming Code: The four digit
Master User: A user which has a
code required when entering
Primary and Secondary Code which
programming mode, deleting users,
are the same, and can gain access in
and resetting the AC-G43 to its
any Mode of Operation.
factory default settings.
Mode of Operation: The state of
Programming Mode: The mode
operation of the controller. There are
used when programming the AC-
three "Modes": Normal Mode,
G43's system settings.
Bypass Mode, and Secure Mode.
Proximity Cards: A contactless
N
(RFID) identification card each with
unique code.
Normal Mode: The system setting
(Mode of Operation) in which all valid
users have access upon presenting a
valid Proximity Card or PIN Code
(Primary Code).
Normal / Bypass Code: The four
digit code used to change the
controllers Mode of Operation from
Page 43
07/04
To Next Page
Loading...
Need help?
General
