Table of Contents
iv AYC-Qx4 Family Installation and Programming Manual
5.2 Modes of Operation .............................................................. 33
5.2.1 Normal Mode ............................................................................... 33
5.2.2 Bypass Mode ................................................................................ 33
5.2.3 Secure Mode ................................................................................ 34
5.2.4 Changing the Modes of Operation ............................................... 34
5.3 Auxiliary Input and Output..................................................... 35
5.4 Door Alarms ......................................................................... 35
5.5 Internal Case and Back Tamper .............................................. 36
5.6 Lockout Feature (Keypad/Card Tamper) .................................. 36
5.7 REX Function ........................................................................ 36
5.8 Secured Intelligent Power Supply ........................................... 37
5.9 Programming as a Controller ................................................. 37
5.9.1 Entering Programming Mode ........................................................ 38
5.9.2 Exiting Programming Mode .......................................................... 39
5.9.3 Changing Lock Strike Code .......................................................... 39
5.9.4 Changing Auxiliary Code .............................................................. 40
5.9.5 Changing the Programming Code ................................................ 41
5.9.6 Changing the Normal/Secure Code .............................................. 41
5.9.7 Changing the Normal/Bypass Code and Door Chime Settings ...... 42
5.9.8 Setting Fail Safe/Secure Operation, Tamper Siren and Lock Strike
Release Time ................................................................................. 43
5.9.9 Defining the Auxiliary Input and Output ....................................... 44
5.9.10 Setting the Lockout Feature .......................................................... 49
5.9.11 Setting the Backlight Behavior ...................................................... 50
5.9.12 Enrolling Primary and Secondary Codes ........................................ 51
5.9.13 Deleting Primary and Secondary Codes ......................................... 55
5.9.14 Relay Codes Assignment ............................................................... 57
5.9.15 Relay Code Assignment using Standard Method .......................... 57
To Next Page
Loading...
