PRELIMINARY CHECKS
Unpacking Massage Chair Cartons
1.Lift the carton
2.Flip down the leg unit
3.Install the touch-screen controller
12
Unpack the carton and take all massage chair units out of the carton.
Remove secure straps and lift the carton vertically, flip down the leg unit.
Do not disassemble this product yourself to avoid product failure.
Make sure no water or other liquid enters into the controller to avoid fault.
Do not pinch or squeeze the controller or power cord.
Take out the user manual, power cable,touch screen controller and controller
stand.
Remove the rubber tip, insert the lower end of controller stand into the
socket and turn clockwise to secure the stand into place, connect the
controller connectors.
Plug the power cord into the chair and connect to the power outlet, turn on
the main power switch, you are set to go. (check below fig.)
CAUTION
To Next Page
