USER'S AND
MAINTENANCE
MANUAL
01/31/2020
Air Compressor : D185T4F-DB
Copyright © 2014, ROTAIR S.P.A. - All rights reserved. This manual is intellectual property of ROTAIR S.P.A.
Its full or partial reproduction is forbidden under any form, on any support and by any means, without the
written authorization by ROTAIR S.P.A.
ROTAIR S.P.A. is available to its customers for any further information. Please report the information (type of
machinery, model, and code) found on the machinery identification nameplate. All of the specific data not
indicated in the text are mentioned in the chapter "Technical Specifications of the Machinery" as well as in the
technical annexes of this user's and maintenance manual.
This manual thoroughly describes:
- The information relevant to, lifting, and parking of the machinery
- The general rules and recommendations useful for routine and extraordinary maintenance
- The procedures to identify and order the parts
Remark: the instructions for the appropriate use of the engine are described in the manual drafted by the engine
manufacturer.
This manual must be preserved with care in its folder, far from sources of humidity, heat, and sun rays so that
it can be consulted at any time by both the personnel appointed to its use and by those who need to perform
routine and extraordinary maintenance. This machinery has been exclusively designed and manufactured to
deliver compressed air in the conditions stated by the manufacturer. Every other utilization not mentioned in
the "expected uses" shall relieve the manufacturer from any liabilities, which will be at full liability of the user.
“Approved purpose" assumes compliance with the recommendations reported and related to the appropriate
use and maintenance, as well as to the transport of the unit. All of the accident prevention regulations and
standards in force need to be complied with as well, besides complying with the general rules in terms of
safety and occupational medicine which are governed by the legislation in force.
The manufacturer declines any responsibility in case of changes made on the machinery without its
authorization. Before commissioning, the buyer must ascertain that ANY equipment or machinery,
components, and protection installations that are not part of this machinery comply with Machine Directive
2006/42/CE and to the other applicable European Directives (2006/95/CE - 2004/108/CE, etc.).
To Next Page
Loading...
Need help?
General
