To Next PageTo Next PageWhat to do if temperature sensors are defective in Rotair Dustless Blasting D185T4F-DB?
If the temperature sensors are defective in your Rotair Air Compressor, unplug the wire from each sensor, one at a time, to identify the defective one. The temperature light on the control panel should go off when the faulty sensor is disconnected. Replace the defective sensor.
What to do if there is air in the fuel pipe of Rotair Dustless Blasting D185T4F-DB?
If there is air in the fuel pipe of your Rotair Air Compressor, carefully inspect all fuel lines to locate the leak and make necessary repairs.
What to do if Rotair Dustless Blasting D185T4F-DB has no fuel?
If your Rotair Air Compressor has no fuel, top off the fuel in the diesel tank.
How to fix oxidized or loose terminals of the battery cables in Rotair Dustless Blasting D185T4F-DB Air Compressor?
If the terminals of the battery cables of your Rotair Air Compressor are oxidized or loose, clean or tighten the connections.
How to fix discharged or defective battery in Rotair Dustless Blasting D185T4F-DB Air Compressor?
If the battery of your Rotair Air Compressor is discharged or defective, recharge it and replace it if necessary.
General| Brand | Rotair |
|---|---|
| Model | Dustless Blasting D185T4F-DB |
| Category | Air Compressor |
| Language | English |
Physical and operational parameters of the D185T4F-DB model.
Performance and capacity data of the compressor unit.
Pictograms and definitions for various types of hazards.
Instructions on what NOT to do for safety.
Description of permitted applications for the air compressor.
Prohibited uses and disclaimer for non-compliance.
Potential hazards and precautions during operation.
Safety precautions to be taken during maintenance operations.
Explanation of warning and indicator lights on the panel.
Overview of air intake, compression, and regulation.
Pre-operation checks and procedures.
Steps for starting the engine and compressor.
Precautions and checks during machine operation.
How to check and adjust engine RPM.
Procedure for adjusting idle engine speed.
Procedure for calibrating maximum air pressure.
Procedure for calibrating minimum air pressure.
Schedule of recommended maintenance operations.
Procedure for changing the compressor oil.
