Rotair Dustless Blasting D185T4F-DB User Manual

USER'S AND
MAINTENANCE
MANUAL
Date:
01/31/2020
Code
MAN D185T4F-DB
ENG
Air Compressor : D185T4F-DB
Revision
03
Copyright © 2014, ROTAIR S.P.A. - All rights reserved. This manual is intellectual property of ROTAIR S.P.A.
Its full or partial reproduction is forbidden under any form, on any support and by any means, without the
written authorization by ROTAIR S.P.A.
Page
49/59
13.4-3 FUSE REPLACEMENT
Fuse replacement should be performed when one or both fuses are damaged.
To replace the fuse, proceed as follows:
1) Stop the machine
2) Open the hood
3) Open the fuse box
4) Pull the fuse to be replaced with tweezers (to fuse 15 A) or remove the nuts for the 40 A fuses
5) Once the fuse has been removed, observe the internal filament. This must be intact to function
properly, and if it is intact, reinstall the fuse
6) In the event of a open/broken fuse, replace it by choosing a fuse with identical ratings. The ratings of
the fuses are described in Section 8.3 of this manual

Rotair Dustless Blasting D185T4F-DB Specifications

General

Brand	Rotair
Model	Dustless Blasting D185T4F-DB
Category	Air Compressor
Language	English