17
Shoulder Bolt
Cable Clamp
Feed cable up through Cable
Clamp, loop over end of
shoulder bolt and feed back
down through Cable Clamp.
(2) 3/8" Retaining
Fig. 19
5/16-18NC x 3/8" lg. PHMS
Latch handle MUST be
positioned at the top of
the latch control cover.
Ball Handle
Fig. 20
Using wire ties provided, tie off cable guide
to column extension as shown, Fig. 16a. Guide must
be attached in hole closest to the outside edge of the
column on the NON-APPROACH side.
G) Bring the cable down inside the left column and feed
the end of the cable through the lower latch cable
sheave slot so that the cable is now back outside the
column, Fig. 19.
H) Install latch cable sheave and retaining rings in lower
slot of non-power unit column as shown, Fig. 19.
I) Route cable under the bottom side of the latch cable
sheave, Fig. 19.
J) At this point you MUST install the latch handle, jam nut,
and right column latch cover Fig. 17 & Fig. 20. Install
latch handle ball, Fig. 20.
K) Insert cable in cable clamp along one side, loop around
shoulder screw and back down, inserting cable along
other side of cable clamp, Fig. 19. Place top back on
clamp, barely tightening.
L) Next, pull the control plate down, Fig. 18 & Fig. 19, to
eliminate any clearance between the control plate slot
and the latch dog pin, Fig. 18.
M) Using Pliers, pull cable tight and secure the clamp close
to the shoulder screw. Tighten clamp.
To Next Page
Loading...
