Rotary 2000 Series - Locking Latch Cable Installation; Latch Cable Sheave and Loop; Latch Cable Conduit Guide Brackets

16
12. Locking Latch Cable
A) Install latch cable sheave and retaining
rings in upper slot of power unit column as
shown, Fig. 17.
B) Slip loop end of cable over end of shoulder
screw on right side latch control plate, Fig.
17.
C) Feed the other end of the cable through the
latch cable sheave slot making sure that
the cable is running under the bottom side
of the latch cable sheave and inside the
right column, Fig. 17.
D) Attach latch cable conduit guide brackets to overhead
as shown, Fig. 16a & Fig. 16b. Always use the holes on
the approach side of the lift. HHCS should be in hole
nearest the center of the overhead, Fig. 16b.
E) Route cable up inside column and through the latch
cable guide, Fig. 16a & Fig. 18.
IMPORTANT
Using wire ties provided, tie off cable guide
to column extension as shown, Fig. 16a. Guide must
be attached in hole closest to the outside edge of the
column on the NON-APPROACH side.
F) Continue routing cable to the left column latch cable
guide, Fig. 16a & Fig. 18, routing the cable through the
left column latch cable guide, Fig. 16a.
(2) 3/8" Retaining Rings
Latch Cable Sheave
Shoulder Bolt
Install Latch Handle using a 3/8"
hex jam nut to lock in place. Then
install flat washers and slot cover.
(3) 3/8” Flat Washers
Slot Cover
Fig. 17
Latch Cable Guide
Right Column
Latch Cable
Notice the clearance
removed between
Control Plate Slot
and Latch Dog Pin.
Fig. 18