To Next PageTo Next Page
Need help?Do you have a question about the Rotary 2000 Series and is the answer not in the manual?
General| Brand | Rotary |
|---|---|
| Model | 2000 Series |
| Category | Lifting Systems |
| Language | English |
Refer to ANSI/ALI ALIS Safety Requirements for Installation and Service of Automotive Lifts before installing lift.
Specifies operating conditions including temperature range and outdoor use restriction.
Instructions on applying grease to lift columns for proper sliding contact.
Diagram illustrating minimum clearance dimensions for SPOA7 lift in a bay.
Diagram illustrating minimum clearance dimensions for SPOA10 lift in a bay.
Diagram illustrating minimum clearance dimensions for SP010 lift in a bay.
Diagram for SPOA7 and SPOA10 seismic base plate bay layout dimensions.
Diagram for SP010 seismic base plate bay layout dimensions.
Diagram showing EHO column positions with standard and lower height settings.
Diagram showing EH2 column positions with standard and lower height settings.
Diagram showing EHI field retrofit column positions.
Guidance on selecting lift location and determining appropriate lift height.
Instructions for installing column extensions and latch cable conduit guide brackets.
Steps for installing the overhead mounting bracket and setting column positions.
Reference guide for anchor installation, detailing anchor types, torque, and concrete requirements.
Procedure for shimming columns to ensure plumbness and tightening anchor bolts.
Notes on foundation design based on load-bearing values, soil, and load combinations.
Specifications for concrete compressive strength, reinforcing steel, and placement.
Diagram illustrating lift base plate layout, anchor placement, and reinforcement details.
Diagram showing overhead assembly dimensions for the SP010 model.
Diagram showing overhead assembly dimensions for the SPOA10 model.
Diagram showing overhead assembly dimensions for the Wide SPOA10 model.
Diagram showing overhead assembly dimensions for SPOA7/SPOA10NB (Narrow Bay).
Diagram showing overhead assembly dimensions for SPOA7NB (Narrow Bay Setting).
Details of hardware used on the open bar side of the overhead assembly.
Details of hardware used on the switch box side of the overhead assembly.
Instructions for installing the switch box onto the overhead assembly.
Procedure for mounting the power unit bracket and securing nuts.
Instructions for installing and tightening the branch tee to the pump.
Procedure for correctly tightening flared fittings to ensure a pressure-tight seal.
Steps for installing hydraulic adapters and hoses using hose clamps.
Guidance on the general arrangement and routing of equalizing cables.
Procedure for adjusting equalizer cable tension at the upper tie-offs.
Information on the required lengths for pipe spacers based on lift model and configuration.
Instructions for installing the latch cable sheave and retaining rings, and routing the cable loop.
Steps for attaching latch cable conduit guide brackets to the overhead assembly.
Procedure for routing the latch cable through the lower latch cable sheave.
Instructions for installing the latch handle and securing the latch cable with a clamp.
Requirements for electrical power supply, including wire sizing and voltage specifications.
Diagram illustrating the wiring connections for a single-phase motor.
Procedure for filling the hydraulic system with oil and bleeding the cylinders.
Instructions for checking the proper operation of the overhead switch assembly.
Steps for installing lift arms and restraint gears, including torque specifications.
Diagrams illustrating the correct holes to use on the bearing bar for arm installation.
Instructions for installing door bumpers and adjusting the latch cable tension.
Procedure for performing a pressure test and repeating hydraulic cylinder bleeding.
Guidance on checking the tension of the equalizer cables.
Instructions for installing latch release and pinch point decals on the lift columns.
Procedure for installing the wheel spotting dish onto the concrete floor.
Steps to verify proper lift operation, lock function, and hydraulic/electrical systems.
Instructions for the installer regarding the manual and owner handover.
Contact details for Rotary World Headquarters and regional support centers.
