Rotary 2000 Series - Lift Installation Steps; Lift Location and Height; Column Extensions and Latch Cable Guides; Overhead Mounting Bracket and Lift Setting

6
1. Lift Location: Use architects plan when available
to locate lift. Fig. 1a, Fig. 1b, Fig. 1c, Fig. 1d, shows
dimensions of a typical bay layout.
2. Lift Height: See Fig. 3 for overall lift height of each
specic lift model. Add 1” min. to overall height to lowest
obstruction.
WARNING
DO NOT install this lift in a pit or
depression due to re or explosion risks.
3. Column Extensions: Before standing columns upright,
install the column extensions using (12) 3/8”-16NC x 3/4”
Carriage HHCS and Flanged Locknuts, Fig. 3, Fig. 2a, 2c,
and 2d.
Fig. 3
4. Latch Cable Guides: Install the latch cable conduit
guide brackets to column extensions with (1) 1/4”-20NC x
1” HHCS and 1/4”-20NC Flanged Locknuts, Fig. 2b. HHCS
should go through hole nearest the edge as shown, Fig. 2b.
5. Overhead Mounting Bracket: Install Mounting
Brackets to column extensions as shown, Fig. 3.
6. Lift Setting: Position columns in bay using dimensions
shown in Fig. 1a & Fig. 1b. Place column with power unit
mounting bracket on vehicle passenger side of lift. Both
column base plate backs must be square on center line
of lift. Notches are cut into each base plate to indicate
center line of lift. Use appropriate equipment to raise
carriage to rst latch position. Be sure locking latch is
securely engaged.
3/8"-16NC x 3/4" HHCS
& Flanged Locknut
Use (4) 3/8"-16NC x 3/4"
Carriage Bolts and
Flanged Locknuts in
front and (2) in the back
11' 8" (3556mm)
Top of Overhead
Assembly(std.)
11' 4" (3454mm)
Top of Overhead
Assembly
(Low Ceiling)
12' 0" (3658mm)
Top of Cylinder
68" rise lifts
Overhead Assembly
Mounting
Bracket
12' 6" (3810mm)
Top of Cylinder
71" rise lifts