Rotary 2000 Series - Decal Application and Final Checks; Decal Installation; Wheel Spotting Dish Installation; Final Operation Verification

22
Raise Lift Off
Latches
Actuate To Release
Latches
Pinch Point
CAUTION
NP266 Rev C
Raise Lift Off
Latches
Actuate To Release
Latches
Pinch Point
CAUTION
NP266 Rev C
WARNING
Keep feet
clear of lift
while lowering
8"
Fig. 30
Fig. 31
Fig. 32
22. Latch Release Decal: Install latch release decal on
cover above latch release handle, Fig. 30.
23. Pinch Point Decal Location: Install enclosed pinch
point decals. Place (1) decal on each column, Fig. 31.
Decals should be a minimum of 8” (20.3 cm) from the
bottom of decal to the ground.
24. Wheel Spotting Dish: Position wheel spotting dish as
illustrated in Fig. 1a or 1b. Drill (2) 3/8” holes 2-1/2”
(64 mm) deep in concrete oor using holes in wheel
spotting dish as guide. Drive both anchors, provided, into
concrete to secure dish, Fig 32.
25. Upon completion of the assembly of the lift, the lift is
to be operated to assure proper function. Observe for
locks operating in all locking positions, each side lifts
equally, hydraulics do not leak, all electrical controls
function as labeled, all pneumatics are functional and
leak free, ramps rotate freely (if applicable), and proper
clearances with all items in bay have been maintained.
Operate the lift with a typical vehicle and observe
to assure the same items for proper functioning.