11
Inspection Points
REPAIR MAINTENANCE
(MAINTENANCE AUTHORIZED BY QUALIFIED SERVICE REPRESENTATIVE ONLY)
Aside from the routine checks that are stated under "Operator Maintenance", the following
annual inspection is to be performed and a record of this inspection permanently retained on
site. All deficiencies are to be corrected by the proper authorized personnel.
Annual Inspection
(performed by Authorized Personnel)
• Lockout any energy sources before beginning any repairs.
• DO NOT modify the lift in any manner without the prior
written consent of the manufacturer.
• If electrical problems develop, make repairs according to
local electrical codes. Use genuine Rotary Lift parts when
replacement is necessary.
• Replace worn parts as required with genuine
Rotary parts.
• Adjust equalizer cable tension per lift installation
instructions.
• Monthly: Lubricate locking latch shafts. Push latch
handle several times for oil to penetrate joints.
• Check accessibility of the operating procedures.
• Check accessibility and readability of all labels.
• Check the rated load capacity of the lift.
• Examine all structural components including welds.
• Check electrical cords for insulation damage.
• Check fluid level.
• Check the lift controls for function.
• Check all fastening devices for tightness including floor anchor bolts.
• Check exposed surfaces and edges.
• Operate the lift and check the operation of the positive stop and the lift safety latches.
• Check for proper operation of lifting devices.
• With a representative vehicle on the lift, check the lowering speed (not to exceed 0.15m/s).
• Check the operation of the synchronization or equalization system so that both sides raise and lower equally.
• *Check the function of overhead switch and/or overhead sensors (Overhead sensors only on E and i series lifts).
• Check all accessible piping, tubing, hose, valves and fittings. Review lift oil consumption records.
• *Operate lift through full excursion and observe.
• With lift loaded, stop the lift at midpoint of travel and observe for drifting down and hydraulic leaks.
• Check with operator to ascertain any unusual operating characteristics.
*
Perform check with and without a vehicle representative load.
To Next Page
Loading...
