Rotary E Series - i Series Lift Raise Issues

13
Trouble
Error message on
LCD
No error message on LCD
Locking latches will not engage
Cause
1. Overhead Sensor Fault
2. Power unit circuit fault
1. Touchpad not functioning
1. Broken latch spring
Remedy
1. Check sensor for contact with
vehicle.
2. Have certified electrician check
wiring to power unit.
1. Replace touchpad.
1. Replace latch spring
TROUBLE SHOOTING FOR AUTHORIZED MAINTENANCE PERSONNEL
FOR i Series Lifts
Up button pressed but lift doesn't raise
Trouble
Lift stops short of full rise or
chatters.
Cause
1. Low oil level
2. Air in hydraulic lines/cylinder
Remedy
1. Fill tank to MIN___ mark with
ISOVG32 hydraulic oil or
DexronIII ATF.
2. Start unit, raise lift about
610mm. Open cylinder bleeders
approximately 2 turns. Close
bleeders when fluid streams.
Lower lift and fill tank.
TROUBLE SHOOTING FOR AUTHORIZED MAINTENANCE PERSONNEL
FOR ALL Series Lifts