Rotary E Series - Trouble Shooting; M Series Lift Issues

To Next Page

To Previous Page

• Always keep bolts tight. Check periodically.

• Always keep lift components clean.

• Always, if oil leakage is observed, call local service repre-

sentative.

• Daily: Check cables and sheaves for wear. If parts are

worn, call local service representative.

• Daily: Inspect lifting devices for damage or excessive wear.

If parts are worn, call local service representative.

• Daily: Check for permanent deformation to the latches. If

present, call local service representative to replace parts.

• Monthly: Check equalizer cable tension. If parts are worn,

call local service representative.

• Monthly: Check overhead switch for function.

• Every 3 Months: Check anchor bolts for tightness. Anchors

should be torqued to 122Nm (12.4kg-m).

• Every 6 months: Check fluid level of lift power unit and

refill to proper level in level indicator with lift fully lowered.

• Replace all decals on the lift if unable to read or missing.

Reorder labels from Rotary Lift.

• Monthly: Clean and check base of lift. Remove any rust and

touch-up with paint.

• Monthly: Coat the cable contact surface with a light grease

such as "TUFOIL".

OPERATOR INSPECTION & MAINTENANCE

(MAINTENANCE AUTHORIZED BY OPERATOR)

Cause

1. Blown fuse or circuit breaker.

1. Low oil level.

1. Overloading lift.

See Remedy

Remedy

1. Replace blown fuse or reset circuit

breaker.

2. Contact service representative for

further assistance.

1. Fill tank to MIN___ mark with

ISOVG32 hydraulic oil or

DexronIII ATF.

2. Contact service representative for

further assistance.

1. Check vehicle weight and/or bal-

ance vehicle weight on lift.

2. Contact service representative for

further assistance.