14
ON
OFF
ON
OFF
Emergency Stop Process
Mobile Column wired or wireless Emergency Stop process.
1. Always follow safe lifting practices detailed in the
instruction manual according to ANSI and ALI. Clear the
area if a vehicle or lift is in danger of falling.
2. First actuate the Emergency Stop Switch.
3. If the Emergency Stop Switch does not affect the
operation of the system or post, immediately go to the
Main DC Disconnect Switch of the unresponsive unit and
terminate power. This is located on the left hand side panel
as looking at the control panel, Fig. 9.
Fig. 9
To Next Page
Loading...
