Rotel A14 - Technical Specifications; Performance Data and General Information

18
A14 Stereo Integrated Amplier
“Made for iPod,” and “Made for iPhone,” means that an electronic accessory
has been designed to connect specically to iPod or iPhone, respectively, and
has been certied by the developer to meet Apple performance standards.
Apple is not responsible for the operation of this device or its compliance with
safety and regulatory standards. Please note that the use of this accessory
with iPod, or iPhone may affect wireless performance.
iPhone, iPod, iPod classic, iPod nano, and iPod touch are trademarks of
Apple Inc., registered in the U.S. and other countries.
Specications
Continuous Power Output 80 watts/ch
(20 - 20k Hz, < 0.03%, 8 ohms)
Total Harmonic Distortion (20 Hz - 20k Hz, 8 ohms) < 0.03%
Intermodulation Distortion (60 Hz : 7k Hz, 4:1) < 0.03%
Frequency Response
Phono Input 20 Hz - 20k Hz, ± 0.5 dB
Line Level Inputs 10 Hz - 100k Hz, ± 0.5 dB
Damping Factor (20 - 20,000 Hz, 8 ohms) 220
Input Sensitivity / Impedance
Phono Input 3.4 mV / 47k Ohms
Line Level Inputs 230 mV / 24k Ohms
Input Overload
Phone Input 50 mV
Line Level Inputs 4 V
Preamp Output / Impedance 1.2 V / 470 Ohms
Tone Controls - Bass / Treble ± 10 dB at 100 Hz / 10k Hz
Signal to Noise Ratio (A weighting)
Phono Input 90 dB
Line Level Inputs 100 dB
Digital Section
Frequency Response 10Hz - 80k Hz (± 3.0dB,MAX)
Signal to Noise Ratio (A weighting) 103 dB
Input Sensitivity/Impedance 0 dBfs/75 ohms
Preamplifier Output Level 1.3 V (at - 20dB)
Digital Inputs SPDIF LPCM
(up to 192k Hz 24 bit)
PC-USB USB Audio Class 1.0
(up to 96kHz 24bit)
USB Audio Class 2.0
(up to 384kHz 32bit)*
*Driver installation required
DSD and DoP support
General
Power Requirements
USA 120V, 60 Hz
EC 230V, 50 Hz
Standby Power Consumption < 0.5W
Power Consumption 280 Watts
BTU (4 ohms, 1/8th power) 632 BTU/h
Rear USB Output 5 V / 0.5 A
Dimensions (W, H, D) 430 x 93 x 345 mm
17” x 3
5
/8” x 13
1
/2”
Panel Height 80 mm / 3
1
/8”.
Weight (net) 8.2 kg, 18 lbs.
All specications are accurate at the time of printing.
Rotel reserves the right to make improvements without notice.
Rotel and the Rotel HiFi logo are registered trademarks of The Rotel Co., Ltd.
Tokyo, Japan.