Technical
Manual
STEREO POWER AMPLIFIER
RKB-650
Table of Contents
Specification
Specification.....................................1
Parts List..........................................2~6
Adjustment.......................................7
PCB Assembly.................................9~10
Schematic Diagram..........................11~12
BUNZAN-SHINSEN-BLD. 4F 10-10 SHINSEN-CHO, SHIBUYA-KU,
TOKYO 150-0045, JAPAN
Serial. NO.
®
Quality Uncompromised
Y-382A-0505/pdf
Continuous Power Output into 8 ohms
(20-20kHz, < 0.03% THD)2
6x50 watts/ch into 8 ohms, all channel driven
Continuous Power Output into 4 ohms
(DIN 1 kHz,1.0% THD)D
6x80 watts/ch into 4 ohms, all channels driven
Total Harmonic Distortiono
(20Hz-20kHz, 8 ohms)2
Continuous rated power. <0.03%
One-half rated power. <0.03%
1 watt power. <0.03%
Intermodulation Distortion
(60 Hz : 7 kHz, 4:1)
< 0.03%
Danping Factor
(20-20,000 Hz, 8 ohms)
>200
Input Impedance
20 k Ohms
Input Sensitivity
1.0 volt
Amplifier Gain:
26 dB
Input Overload Level
5.0 volt
Peak Current
> 25 A
Frequency Response (±1 dB)
10Hz-100kHz
S/N Ratio (IHF A)
115 dB
Crosstalk/Separation
> 70 dB
Speaker Impedance
4 ohms minimum
Auto Turn On Level (with all inputs)
1 mV input signal
Power Requirements
USA: 120 Volts, 60 Hz
Europe: 230 Volts, 50 Hz
Power Consumption
450 Watts
Idle: 42 Wattsd
Standby: 2.6 Watts
Dimensions (W x H x D)
(not including rack adaptors)n
430 x 144 x 429 mm
16.9 x 5.7 x 16.9 in
Weight (net)
15.5 kg, 34.1 lb.
Panel Height
3U, 132.6 mm/5.2 in
Assembled View...............................8
To Next Page
Need help?
General
Weight and Dimensions
