Need help?Do you have a question about the Rotel RX-1050 and is the answer not in the manual?
Guides on using the remote for the RX-1050.
Connects left and right speakers to the receiver's amplifier.
Allows connection of external amplifiers or use of the receiver as a pre-amp.
Controls independent power for the secondary listening zone.
Operates Zone 2 settings from the RX-1050's front panel.
Manages Zone 2 using the remote and an IR repeater system.
Line-level outputs for connecting speakers in a secondary zone.
Input for IR repeater signals to control Zone 2 remotely.
Thermal protection circuit for the amplifier, ensuring safe operation.
Technical specifications for the audio performance of the receiver.
Technical specifications for the FM tuner section.
Technical specifications for the AM tuner section.
General| Total Harmonic Distortion | 0.03% |
|---|---|
| Speaker Impedance | 4 - 16 ohms |
| Power Output | 100 watts per channel into 8Ω (stereo) |
| Signal-to-Noise Ratio | 100 dB |
| Damping Factor | 100 |
| Input Impedance | 47 kΩ |
| Tuning range | FM: 87.5 - 108 MHz, AM: 530 - 1710 kHz |
| Frequency Response | 10Hz to 100kHz |
To Next Page
