Rotel RX-855 - User Manual

Connect AC line cord directly to a household wall outlet matching unit's voltage rating.

Avoid electric shock and component damage; consult a qualified electrician if foreign objects fall inside.

Immediately disconnect AC cord and consult dealer if unit becomes wet to prevent hazards.

Use speakers with 4-16 ohms impedance; 8-16 ohms for two sets. Check speaker impedance ratings.

Connect speaker leads to DIRECT/REMOTE terminals, matching polarity (+/-) and strip wire ends.

Connect audio components using RCA pin cords, matching L/R terminals. Ground turntable to GND terminal.

Select radio band, tune station using tuning or station buttons, and adjust volume.

Allows auto tuning, manual tuning, and preset memory tuning for station selection.

Store favorite station frequencies in memory for quick recall.

Selects gain for MM or MC phono cartridges; activates built-in MC head amplifier.

Allows tape-to-tape dubbing between two decks via a single switching operation.

Troubleshoot hum by disconnecting components, moving turntable, or checking cables and nearby AC fields.

Details continuous power output, DIN power, music power, distortion, and input sensitivity.

Provides usable sensitivity, distortion, frequency response, and separation details.

Lists sensitivity, selectivity, signal-to-noise ratio, and response ratios.