Need help?Do you have a question about the Rotel RX-1052 and is the answer not in the manual?
Covers placement, heat, water, cleaning, power cord, electrical connections, and accessory usage.
Details the various input and output ports located on the rear panel.
Details the layout and functions of the receiver's front panel and remote.
Covers fundamental operations like power, volume, input selection, and AM/FM tuning.
Details rear panel ports for audio/video sources like Phono, CD, Tape, and Video inputs/outputs.
Explains connections for speakers, remote zones, and preamp outputs.
Details controls for power, volume, muting, tone, and headphone output.
Explains how to select audio/video inputs and control speaker outputs.
Covers power modes, standby operation, and volume adjustments.
Explains audio muting, speaker output selection, and tone adjustments.
Guides on selecting inputs for listening, recording, and remote zones.
Addresses issues related to unit power, sound output, and video connection.
Covers troubleshooting for control operation, display problems, and input switching.
General| Signal to Noise Ratio | 100dB (line) |
|---|---|
| Speaker load impedance | 4 - 16 ohms |
| Power Output | 100 W per channel (8 ohms) |
| Tuning range | FM: 87.5-108MHz, AM: 522-1611kHz |
| Frequency Response | 10Hz to 100kHz |
| Total Harmonic Distortion | 0.03% |
| Output | 1V (Pre out) |
To Next Page
