Rover K Series 1.8 VVC User Manual

Workbook
Engine K Series 1.8 VVC
Rover Group are constantly seeking ways to improve the specification and design of its
vehicles and alterations take place continually.
Whilst every effort is made to produce up-to-date literature, this training workbook should
not be regarded as an infallible guide to current specification, nor does it constitute an
offer for the fitment of any particular system or component.
All rights reserved. no part of this Training Workbook may be reproduced without
prior permission of -
TECHNICAL ACADEMY
GAYDON TEST CENTRE
BANBURY ROAD
LIGHTHORNE
WARWICK
CV35 0RG
This Training Workbook is designed to support the Service Product Training courses and
is issued as part of the training programme.
It may be used to compliment other literature available but the Repair Operations Manual
should always be consulted prior to servicing or repair work.
© ROVER GROUP LIMITED - Nov 1997

Rover K Series 1.8 VVC Specifications

General

Displacement	1796 cc
Valvetrain	DOHC
VVC Technology	Variable Valve Control
Fuel Type	Petrol
Cylinders	4
Valves per Cylinder	4
Engine Type	Inline 4 cylinder
Power Output	143 hp
Torque	174 Nm (128 lb-ft) at 4500 rpm
Fuel System	Multipoint fuel injection

Summary

Variable Valve Control - VVC

How VVC Works

Explains the operating principles of the VVC mechanism.

VVC Technical Specifications

Camshaft Timing Belt

New Timing Belt (front)

Camshaft Drive Belt (Remove)

Camshaft Drive Belt (Refit)

Camshaft Rear Timing Belt

Removal

Procedure for removing the rear camshaft timing belt.

Refit

Procedure for refitting the rear camshaft timing belt.

Camshaft Oil Seals

Cylinder Head (Dismantle)

Camshaft End-float

Camshaft Carrier (Remove)

VVC Cylinder Head Data

Hydraulic Control Unit (HCU)

Information and dismantling procedures for the Hydraulic Control Unit.

Cylinder Head Reassemble

Cylinder Head - Refit