ROVI X3 - Seat and Frame; Wheels and Tires

III
30
· CAUTION UseonlypartsandaccessoriesauthorizedbyROVI
®
Mobility.
Unapprovedtires,batteries,andotherequipmentcouldmake
your wheelchair unstable or dangerous. Such use may also void
the warranty on the wheelchair.
Seat and Frame
Inspect the seat, armrests, cushions, lap belt, and footplate. Inspect the lap belt carefully - it is there
for your safety. Make sure it is not fraying or damaged and that it is attached securely to the power-
wheelchair frame. Inspect the buckle and make sure it locks securely.
Inspect the seat cushions for wear and replace them if necessary. Make sure that the seat is fastened
securely to the frame. Look for missing fasteners or sharp edges on any seat hardware.
Check the footplate assembly and make sure there are no broken or missing parts. Make sure that
your footplate is adjusted properly according to your requirements.
Wheels and Tires
The wheels and tires should be checked periodically for cracks and wear and replaced if necessary.
The condition of the tires depends on how you drive and use your power wheelchair. Because your tires
are flat-free tires, there is no need to worry about tire air pressure. Make sure the wheels have no
“sideplay,” wobbling, or flutter when turning. Tighten loose wheel bolts and caster nuts on a regular
basis.
Inspect caster assemblies for wear and proper tightness by spinning the wheel and observing for
free movement or wobble of the wheel. Beware of caster flutter, side-to-side motion, which may
occur at high speeds. If the casters flutter, replace them immediately.
Note: Make sure that all four casters are touching the ground appropriately.
It is recommended that the driving axles (inside the drive wheel assembly) and caster assemblies
be checked and cleaned occasionally for debris buildup, which will hinder the performance of the
unit.