OPERATION
Plug the appliance into the mains socket.
Turning ON/OFF
Repeatedly press to select the desired working mode: automatic,
The indicator of your selected mode will illuminate.
Mode selection
When the fan ( ) and dehumidi cation ( ) modes are selected, the
display will show the ambient room temperature.
Repeatedly press +/- on the control panel or / on the remote to set the temperature.
The display will show the temperature you set in auto ( ), and cooling ( ) modes.
Adjustable temperature range:
30°C (86°F) max.
17°C (62°F) min.
The temperature can be displayed in degrees Fahrenheit or degrees Celsius. To change the display from one
to the other, press and hold + and - on the control panel at the same time for about 3 seconds.
Setting the temperature
Repeatedly press to select the fan speed.
The speed indicator light will illuminate to indicate which speed setting is in use.
If the appliance is in auto ( ) and dehumidification ( ) modes, you can not select the fan
speed.
Setting the fan speed
You can set the timer for both delay start and delay stop.
Programming the timer for ON – when the appliance is OFF.
Press on the control panel or on the remote control. The timer on indicator light will illumiante on the
control panel.
Repeatedly press or hold down +/- on the control panel or on the remote control to change the time in half an hour
increments up to 10 hours, and then in 1 hour increments up to 24 hours.
The set time will be con rmed after about 5 seconds and then the delay start timer will start.
When the set time has been reached, the appliance will turn on automatically.
Setting the timer
Programming the timer for OFF – when the appliance is operating.
illuminate on the control panel.
On the control panel On the remote control
EN
11
To Next Page
Loading...
Need help?
General
