Royal Catering RCSI-16A - Page 32

EN
The clutch or mixer is
damaged.
Replace the clutch or mixer.
The ice cream is too soft
The dispenser opening is
leaking.
Check the piston O-ring and replace it if
necessary.
The dispenser door is leaking.
Check the dispenser door O-ring and
replace it if necessary.
The drain pipe is leaking.
Check the screw seal and replace it if
necessary.
The buzzer keeps beeping
Low voltage protection.
Turn off the device first, then turn it on
after 5 minutes.
Shutdown protection.
Turn off the device first, then turn it on
after 5 minutes.
Limit switch does not reset in
time.
Pull the handle up to reset the limit
switch.
CODE "NL".
The speed of the drive motor
decreases rapidly.
The hardness is set too high or check if
it is a motor problem.
"--"CODE
The proximity switch is not in
the correct position or is
damaged.
Adjust the position of the proximity
switch or replace it.