Royal Enfield Classic 350 User Manual

Royal Eneld All New Classic 350/Signals 350
86
STORAGE PRECAUTIONS
In-case your motorcycle is not going to be used for a
month or more, the following precautions should be
taken.
 Get the motorcycle serviced through a Royal
Eneld Authorised Service Centre.
 Drain the fuel completely from the fuel tank and
induction system.
 Remove spark plug, Pour in about 5 ml of clean
engine oil through spark plug hole. Close the hold
and crank engine several times and ret spark plug.
 Clean drive chain thoroughly and apply Royal
Eneld recommended chain lubricant.
 Wipe o excess lubricant after 5min of application.
 Remove charging circuit fuse from the fuse box.
 Store the battery in a cool, dry and well ventilated
place.
 Cover the silencer with suitable bags to prevent
moisture entry. Set the motorcycle on its center
stand.
 Apply anti rust solutions on all plated parts. Take
care not to apply this solution on chrome, rubber or
pained parts. Store motorcycle in a clean covered
area free of moisture and dust.
 For re-use after storage, it is preferable to get
the motorcycle prepared through a Royal Eneld
Authorised Service Centre to ensure the motor-
cycle is restored to its peak operating conditions.
 Battery (+ve) connector can be disconnected to
avoid battery drain issue in longterm.

Royal Enfield Classic 350 Specifications

General

Engine Type	Single Cylinder, 4 Stroke, Air-Oil Cooled
Max Torque	27 Nm @ 4000 rpm
Fuel System	Electronic Fuel Injection
Transmission	5-speed Constant Mesh
Front Suspension	Telescopic, 41mm forks, 130mm travel
Rear Suspension	Twin tube emulsion shock absorbers with 6-step adjustable preload
Kerb Weight	195 kg
Seat Height	805 mm
Ground Clearance	170 mm
Wheelbase	1390 mm
Front Brake	Single 300mm disc, twin-piston floating caliper
Rear Brake	Disc, 270 mm
Fuel Tank Capacity	13 liters
Max Power	20.2 bhp @ 6100 rpm