3-2
3.1 HOLDING THE SAMPLE
In order to ensure accurate test results, determine the optimal sample holder, secure the
sample in the holder, and position the sample holder on the base plate in an appropriate
position for testing. Generally, choices should be made with test accuracy as the first
criteria.
3.2 INSTALLING THE TEST HOOK
Place the hook on the shaft extending from the bottom of the test head, then tighten the
set screw on the hook body. Be careful when installing the test hook, the test head is
sensitive and can be damaged by excessive contact.
Wire diameter is the main factor that influences hook choice, however wire spacing may
also need to be considered. Generally, the diameter of the hook should be 2 times the
diameter of the wire being tested.
3.3 USING THE “TEST SETUP” MENU
The Test Setup menu contains a number of high level options which govern the
operation of the system. Test parameters, printer output, time, date, operator
identification, and sample identification settings are entered from this menu. Test Setup
settings are stored in non-volatile memory and remain in effect until edited by an
operator. A description of all Test Setup menu choices follows.
NDT LIMIT
This selection allows the operator to set the force limit for non-destruct testing. To
set the limit, use the left and right mouse buttons to increase or decrease the limit
value, then press the center mouse button to accept the value.
PRINTER
This selection allows the operator to switch the printer ON or OFF. When ON, the
printer will print each test as it is completed. When OFF, test results appear only
on the test screen, and only until the next test is run.
NAME:
This selection allows the operator to enter or select an operator identification
name. Use the left and right mouse buttons to scroll through the default operator
ID numbers, use the center mouse button to select a number of your choice. If the
keypad is installed, the default ID designations may be edited. When the selection
is completed, press the center mouse button to set selection.
PART:
This selection allows the operator to enter or select a part identification
designation. Use the left and right mouse buttons to scroll through the default part
ID numbers, use the center mouse button to select a number of your choice. If the
keypad is installed, the default part ID designations may be edited. When the
selection is completed, press the center mouse button to set selection.
To Next Page
Loading...