CSD5 Servo Drive
P-6 Preface
Safety Precautions
This is CSD5 User Manual describes safety matters using the following marks.
Safety marks deals with the important matters. If the following marks and
contents of each mark are indicated in the contents of this user's manual, you
must be fully aware of them and follow them.
Usage
Storage
Transportation
• Do not touch the inside of servo drive.
• Make sure that the servo drive and the motor are fully
grounded.
• Completely discharged before handling after power
off.
• Do not put excessive stress on the motor power and
encoder cable.
• Never touch the revolving part of the motor during
operation .
• Avoid using the product near wet places or corrosive
and inflammable materials.
• Operate the system with no load during pilot
operation.
• Never touch the heat sink directly.
• Do not store the product near wet places, rain, toxic
gas or fluid.
• Keep the product out of the direct rays of the sun and
store it within the storage temperature and humidity
ranges.
• Avoid overloading if the product is stored in a
warehouse.
• Do not carry the product by holding the cable and the
motor shaft.
To Next Page
