7 CSD5 Servo Drive
Preface P-7
Installation and Wiring
Maintenance and Repair
• Install a cooling fan to prevent excessive temperature
increase. (Refer to the Chapter 2)
• Be careful not to wiring cables around the heat sink.
• Install drives with regular space (at least 10 mm)
between them.
• Pay attention to the heat sink when wiring. (Refer to
Chapter 2)
• Do not disassemble or remodel the product. Any
damage caused after the user disassembles or
remodels the product will be excluded from the
company's warranty.
• The company bears no responsibility for injuries or
physical damage caused by remodeling of this
product.
• Life-limited Parts by mechanical friction or heat
requires regular . Refer to the Chapter 8.
• In case of a failure that cannot be dealt with, please
contact the company’ s technical support team or
after-sales service center.
To Next Page
